Description of the files.              23.05.2012


Preliminary operations to configure the board

FILA10GSA_load.bat -----------> batch file, run to configure the FILA10G-SA

FiLa10GSA_conf.cmd -----------> instructions used by FILA10GSA_load.bat. 
				IMPORTANT esn must belong to your programmer.
				This numebr can be got running Chipscope. 
				Contact FILA10G support in case of problems.

fila10g_v2_0.bit -------------> firmaware for the FILA10G-SA, uploaded to 
				the board by FILA10GSA_load.bat


After configuration to operate the board

fila10_double.bat ------------> after configuration this file set all variables, change
				at your convenience (see DBBC2 FILA10G Command set v2_0.pdf)

timesyncFILA10G.exe ----------> executable file used by fila10_double.bat

vdif_timesyncFILA10G.exe -----> executable file used by fila10_double.bat

sendstr.exe ------------------> executable file used by fila10_double.bat


Manuals and table

DBBC2 FILA10G Command set v2_0.pdf ------------> Manual of the commands through the serial 
						 port. For interactive control use for ex. Putty, 
						 for a sequence use a batch file (ex. fila10_double.bat)

DBBC2 FILA10G VDIF_Size-MaxNumber Table.pdf ---> Table of allowed packet sizes and number 
						 of packets per second.